Skip to main navigation Skip to main content Skip to page footer

01

Selection criteria

What surface result should the nonwoven belt achieve?

Start with the workpiece: Which material are you processing, which marks or burrs are present, and what should the surface look like afterwards? Nonwoven belts can be used for cleaning, satin finishing, finishing and light deburring. Contact area, contours, machine, current belt and its service life also matter. The grade alone describes neither the result nor suitability for your process.

02

NONWOVEN BELTS IN THE RANGE

Nonwoven belts for finishing and surface treatment

The range includes nonwoven belts with different backings, abrasive minerals, grades and belt dimensions. Check each product's specifications against the material, machine and surface finish you need.

No products found

No products are currently listed in this category. Request a call back and we will help you find the right product.

Request a callback

03

CHOOSING BACKING AND FINISH

Match the nonwoven structure, backing and belt guidance

In a nonwoven belt, abrasive minerals are held in an open fibre structure. The backing affects how the belt runs: Scotch-Brite SC-BF has a nylon film backing, SC-BL has a low-stretch backing, and SC-BS uses a scrim backing. The range also includes aluminium oxide and silicon carbide, as well as coarse and fine grades. The right combination depends on the material, initial surface, contours and intended finish.

Assess the belt currently in use alongside service life, surface result and process conditions. For suitable coated abrasives, Krückemeyer GmbH can assess application-specific belt dimensions and joints; backing, geometry and construction set limits. Tell us the material, machine, belt dimensions, current product and the specific issue. This connects product selection with a possible converted version.

04

QUESTIONS ABOUT NONWOVEN BELTS

What is a nonwoven abrasive belt used for?

A nonwoven abrasive belt can be used for cleaning, satin finishing, finishing and light deburring when the product and process suit the application. Its open fibre structure carries abrasive minerals across the surface and can conform to contours. The result also depends on the material, initial condition, applied pressure and machine. Describe both the surface you have and the finish you need before choosing a grade alone.

How do film, low-stretch and scrim backings differ?

They differ in construction and belt guidance. Scotch-Brite SC-BF uses a nylon film backing, SC-BL has a low-stretch backing, and SC-BS has a scrim backing. These differences matter for contours, tracking and machine contact; a backing name alone does not establish machine compatibility. Compare the product information and the belt you currently use with the actual surface result.

Is the grade enough to choose a nonwoven belt?

No. The grade is only one selection factor. Product data lists different abrasive minerals, backings and belt dimensions; the material, existing machining marks and desired finish also affect the choice. If the current belt wears too quickly or leaves an inconsistent surface, we can review the belt construction and process conditions together. A specific recommendation requires details of your application.

What information is needed for a converted nonwoven belt?

Provide the base material or current product, workpiece material, machine, belt width, belt length and target result. Krückemeyer GmbH converts suitable coated abrasives into abrasive belts; whether a particular nonwoven belt can be supplied in the requested form depends on its backing, geometry and joint. Service life or an existing finish problem also helps us assess the options. Feasibility is checked for your specific combination.

05

Request advice

Describe the material, machine, belt currently in use and desired surface finish. We can review the backing, grade and suitable belt dimensions with you; conversion depends on the base material and construction.

Discuss a nonwoven belt for your application

Send us the material, machine, belt dimensions and an image of the desired or current finish. If you have a specific product in mind, you can use the enquiry list.

Jürgen Müller

ABRASIVE TECHNOLOGY ADVICE

Jürgen Müller

Contact for products

Jürgen Müller can discuss the material, finish target and suitability of a nonwoven belt for your process.

Advice and sales to business customers only!